WR250R 12oClockLabs Fixed Rate Turn Signal Flasher

WR250R Blog Categories

Modifications
• Cargo Racks
• Chain/Sprockets
• Exhaust
• Fender Eliminator Kit
• Footpegs
• Fuel Injection Controller
• Gas Tank
• Graphics
• Handguards
• Lighting
• Lowering
• Luggage and Bags
• Mirrors
• Protection
• Radiator Guards
• Seating
• Skid Plates
• Speedometer
• Supermoto Conversion
• Suspension
• Tail Light
• Tires
• Turn Signals
• Wheels

News & Info
Project Bike
Ride Reports

RSS Feed

« Improving the WR250R Edge Tail Light Kit | Main | WR250R Running Light Adapters »

Thursday, March 21, 2013

WR250R 12oClockLabs Fixed Rate Turn Signal Flasher

If you install aftermarket LED Turn Signals/Flashers on your WR250R or WR250X, they will flash at much faster rate than the stock OEM turn signals did. To correct that, you will need to install a 12oClockLabs Fixed Rate Turn Signal Flasher module. This is a very simple install on the WR250R/X. The module plugs in just to the right of the battery location. You simply un-plug the factory turn signal flasher module, and replace it with the 12oClockLabs module as shown in photo above.

Where To Buy:
• 12oClockLabs Fixed Rate Turn Signal Flasher at SRmoto

09:25 AM in WR250R Lighting, WR250R Mods, WR250R Turn Signals | Permalink

Comments

You can follow this conversation by subscribing to the comment feed for this post.

Verify your Comment

Previewing your Comment

Posted by: |

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:

Your comment has been posted. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.